| UEBELHOR GOLF & FITTING CENTER 7611 South Meridian Street Indianapolis, IN 46217 Phone: 317-881-4109 www.ubiegolf.com |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
| STEP 2 Prepare to bend Neck at 90 Degrees in the fixture |
| STEP 1 Place Neck with in deep hole at 90 degrees |
| STEP 3 The next bend is approximately 55 degrees for the first offset bend |
| STEP 5 Bend the next in the opposite direction so that the bends are parallel and shaft is at 90 degrees |
| STEP 4 Place the bent neck in the shallow hole at 180 degrees for the 2nd offset bend |
| STEP 6 Now place the neck behind the brass lever with the shaft protruding from the left side at 90 degrees |
| Step 8 Now Bend the shaft to whatever lie angle is desired |
| Step 7 Example of neck and shaft properly aligned and installed in fixture ready for lie bend |
| Step 9 This shows that the neck has been bent to 72 degree lie |
| Step 10 Neck installed showing 55 degree offset and 72 degree lie angle |
| Pictures of different lie and offset angles that can be made with our Bending System. There are many more configurations possible. |
| Bending Tools Bending Tool - Bending Bar-Magnetic Protractor & bendable necks |
| UEBELHOR GOLF 7611 South Meridian Street Indianapolis, IN 46217 Phone: (317) 881-4109 Fax: (317) 881-5207 Email: ubie44@sbcglobal.net |
| Bending Techniques for our Putter Dealers ! |